Rafael Nunes
Joined Oct 21, 2026
- 0 Threads
- 4 Replies
- 0 Likes received
Recent threads
Nothing posted yet.
Recent replies
-
From the current MW6010-8 Driver Product Manual: Rated voltage: 15–48 V DC Minimum / maximum voltage: 12–72 V DC Rated current: 6 A Maximum line current: 30 A Maximum phase current: 120 A CAN baud…
in GDS68 driver electrical specs and supported communication protocols ·
-
Not required. If the module provides a standard UART TTL interface, you can connect it directly to the Pi's UART. Confirm the UART voltage level (3.3V TTL), the pin definitions (VCC, GND, TX, RX)…
in Yunshis LiDAR straight into Raspberry Pi GPIO UART, or do I need the TTL-to-USB adapter? ·
-
Start with the official development resources: EDULITE A3 GitHub: https://github.com/RobStride/EDULITE_A3 MotorStudio: https://github.com/RobStride/MotorStudio Everything else is under the RobStride…
in Just received a RobStride Edulite A3. Where do I start? ·
-
For the same actuator model the confirmed difference is operating voltage and achievable speed. The 48V version generally reaches a higher maximum speed. Reduction ratio and dimensions are…
in Running 48V DAMIAO actuators on a 24V bus alongside 24V units? ·